buildlasBuild with confidence
Build domainFPV drones
Receiver

RadioMaster DBR4

Four antennas on a 20x20 board, receiving both bands at once.

Specification last checked 2026-07-27

Recorded specification

Every value carries the source it was read from. A property with no recorded source is marked as such rather than presented as a fact. If one of them is wrong, tell us: it is the fastest way it gets fixed.

PropertyValueSource
Control link protocol decides fitThe transmitter-to-receiver RF protocol. NOT the same as the receiver-to-FC serial protocol.ExpressLRSRadioMaster product specificationschecked 2026-07-27Quote 1, below the table
Control bands supported decides fitSome radios and receivers work on more than one band, and a few use both at once.2.4 GHz900 MHz (exact band not published)RadioMaster product specificationschecked 2026-07-27Quote 1, below the table
Receiver output protocol decides fitHow the receiver talks to the flight controller. CRSF is used by both ELRS and Crossfire.CRSFRadioMaster product specificationschecked 2026-07-27Quote 1, below the table
Antenna diversityA second antenna, so the link survives one of them being shadowed by the airframe or pointing the wrong way. On a quad that rotates constantly, that is the difference between a glitch and a failsafe.YesRadioMaster product specificationschecked 2026-07-27Quote 2, below the table
True diversityTwo complete receivers, not just two antennas sharing one. Both are sold as "diversity"; only this one is listening on both at once.YesRadioMaster product specificationschecked 2026-07-27Quote 2, below the table
WeightBuild-critical rather than compat-critical: needed to answer registration and class questions.2.7 gRadioMaster product specificationschecked 2026-07-27Quote 1, below the table
  1. RadioMaster product specificationschecked 2026-07-27DBR4 Dual Band Xross Gemini ExpressLRS Receiver: MCU: ESP32; RF Chips: Semtech LR1121 x 2; Frequency Range: 2.404 - 2.479 GHz / 903.5 - 926.9 MHz; Antennas: 4 Discrete Antennas, 2 x 2.4GHz wires & 2 x 900MHz wires; Weight: Without antennas 2.70g / With antennas 5.30g; Dimensions: 27.20 * 27.20mm with 20x20 Mounting Holes; Working Voltage: DC 4.5 - 8.4V; Bus Interface: CRSF; Telemetry RF Power: Max 100mW; Receiver Refresh Rate: Maximum 500Hz, minimum 50Hz; Firmware: ExpressLRS v3.3.2 pre-installed
  2. RadioMaster product specificationschecked 2026-07-27the DBR4 boasts two dual-band sections, each capable of simultaneously receiving 2.4GHz and 900MHz signals. This innovative design allows for the reception of two data streams simultaneously; 4 Descrete antennas for optimal antenna arrangement

Where to buy

This listing does not say which warehouse ships it. Most orders leave China, so expect import VAT and a carrier handling fee unless an EU warehouse is chosen at checkout.

Some links on this page earn us a commission at no extra cost to you, and that never affects any verdict on it. How this is funded.

What this fits

Checked against every other product in the catalog by the same engine the planner runs, rule by rule. Where a specification is missing the answer is unknown, which is a different answer from compatible.

Flight stack (FC + ESC)

Works with (6)

Flight controller

Works with (3)

Radio

Does not work with (8)Works with (13)Not enough recorded specification (16)

The standards this part is judged by

What the properties above actually mean, which differences are absolute, and where the names used in shops mislead.