iFlight BLITZ F7 stack
The 30x30 F722 stack iFlight fit to their own ready-to-fly drones, with a 55 A ESC.
- Stack mounting pattern30.5 × 30.5 mmHole spacing of the mounting pattern.
- Supported receiver protocolsCRSF, SBUS, F.Port, IBUS, GHST, SRXL2Decides what it fits
- Minimum cell count2 SDecides what it fits
- Maximum cell count6 SDecides what it fits
What this fits
Checked against every other product in the catalog by the same engine the planner runs, rule by rule. Where a specification is missing the answer is unknown, which is a different answer from compatible.
Frame
×Does not work with (9)✓Works with (9)2 not yet judged
All frame · All 20 frame checked against this flight stack (fc + esc)
- ×Does not work with (9)
This board mounts 30.5 × 30.5 mm and the frame accepts 25.5 × 25.5 mm.
Rule: Stack mounting pattern
- BetaFPV Meteor65 Air frame
- BetaFPV Meteor65 frame
- BetaFPV Meteor65 Micro brushless frame
- BetaFPV Meteor75 Air frame
- BetaFPV Pavo25 2.5" cinewhoop frame kit
- BetaFPV Pavo35 3.5" cinewhoop frame kit
- GEPRC CineLog 25 GEP-CL25 frame kit
- GEPRC CineLog30 V3 GEP-CL30 V3 frame kit
- GEPRC CineLog35 V3 GEP-CL35 V3 frame kit
- ✓Works with (9)
The frame accepts a 30.5 × 30.5 mm stack.
Rule: Stack mounting pattern
Show the 2 we cannot judge yet, because a deciding specification is not recorded
- ?Not enough recorded specification (2)
The mounting pattern of one of these is not recorded yet.
Rule: Stack mounting pattern
Receiver
✓Works with (20)
All receiver · All 18 receiver checked against this flight stack (fc + esc)
- ✓Works with (16)
The flight controller supports CRSF.
- ✓Works with (4)
The flight controller supports SBUS.
Battery
×Does not work with (11)17 not yet judged
All battery · All 19 battery checked against this flight stack (fc + esc)
- ×Does not work with (11)
1S is outside the 2–6S range iFlight BLITZ F7 stack accepts.
Show the 17 we cannot judge yet, because a deciding specification is not recorded
- ?Not enough recorded specification (17)
Not enough recorded specification to judge this combination.
Rule: Battery connector match
FPV camera
23 not yet judged
Show the 23 we cannot judge yet, because a deciding specification is not recorded
- ?Not enough recorded specification (23)
Not enough recorded specification to judge this combination.
Goggles
23 not yet judged
Show the 23 we cannot judge yet, because a deciding specification is not recorded
- ?Not enough recorded specification (23)
Not enough recorded specification to judge this combination.
Rule: Video system match
Where to buy
Our partner does not list this exact product yet. The search below looks for it on their site; the price there is theirs, not ours.
- BanggoodNo product page yetNo price recorded.Search Banggood
This listing does not say which warehouse ships it. Most orders leave China, so expect import VAT and a carrier handling fee unless an EU warehouse is chosen at checkout.
Some links on this page earn us a commission at no extra cost to you, and that never affects any verdict on it. How this is funded.
Recorded specification
Every value carries the source it was read from. A property with no recorded source is marked as such rather than presented as a fact. If one of them is wrong, tell us: it is the fastest way it gets fixed.
| Property | Value | Source |
|---|---|---|
| Stack mounting pattern decides fitHole spacing of the mounting pattern. | 30.5 × 30.5 mm | iFlight product specificationschecked 2026-07-27Quote 1, below the table |
| Supported receiver protocols decides fit | CRSFSBUSF.PortIBUSGHSTSRXL2 | Betaflight firmware: src/main/rx/rx.hchecked 2026-07-27Quote 2, below the table |
| Minimum cell count decides fit | 2 S | iFlight product specificationschecked 2026-07-27Quote 1, below the table |
| Maximum cell count decides fit | 6 S | iFlight product specificationschecked 2026-07-27Quote 1, below the table |
| Continuous current decides fitAmps per motor the ESC sustains continuously. Vendors also quote a higher burst figure; this is the continuous one, the number that limits which motors the board can feed. | 55 A | iFlight product specificationschecked 2026-07-27Quote 1, below the table |
- iFlight product specificationschecked 2026-07-27
Our latest BLITZ Stack used in our iFlight BNFs. Ultra fast F7 MCU, powerful 55A for 2-6S batteries. 30,5x30,5 mounting pattern. FC Specifications: MCU: STM32 F722 Gyro: ICM42688 Firmware target: IFRC-IFLIGHT_BLITZ_F722 Mount pattern: 30.5*30.5mm / 4mm PCB hole diameter Dimensions: 36.5*35 mm Weight: 7.8g ESC Specifications Mounting Holes: 30.5*30.5mm/Φ4mm Weight: 15.3g Supports 2-6S lipo input MCU: G071 Constant: 55 Amps Burst: 65 Amps
- Betaflight firmware: src/main/rx/rx.hchecked 2026-07-27
typedef enum { SERIALRX_NONE = 0, SERIALRX_SPEKTRUM2048 = 1, SERIALRX_SBUS = 2, SERIALRX_SUMD = 3, SERIALRX_SUMH = 4, SERIALRX_XBUS_MODE_B = 5, SERIALRX_XBUS_MODE_B_RJ01 = 6, SERIALRX_IBUS = 7, SERIALRX_JETIEXBUS = 8, SERIALRX_CRSF = 9, SERIALRX_SRXL = 10, SERIALRX_TARGET_CUSTOM = 11, SERIALRX_FPORT = 12, SERIALRX_SRXL2 = 13, SERIALRX_GHST = 14, SERIALRX_SPEKTRUM1024 = 15, SERIALRX_MAVLINK = 16 } SerialRXType;
The standards this part is judged by
What the properties above actually mean, which differences are absolute, and where the names used in shops mislead.