buildlasBuild with confidence
Build domainFPV drones
AIO board (FC + ESC)

iFlight BLITZ Whoop F7 AIO V1.1

One board carrying the controller and all four motor drivers, on the 25.5 mm whoop pattern.

Specification last checked 2026-07-27

Recorded specification

Every value carries the source it was read from. A property with no recorded source is marked as such rather than presented as a fact. If one of them is wrong, tell us: it is the fastest way it gets fixed.

PropertyValueSource
Stack mounting pattern decides fitHole spacing of the mounting pattern.25.5 × 25.5 mmRaceDayQuads product specificationschecked 2026-07-27Quote 1, below the table
Supported receiver protocols decides fitCRSFSBUSF.PortIBUSGHSTSRXL2Betaflight firmware: src/main/rx/rx.hchecked 2026-07-27Quote 2, below the table
Minimum cell count decides fit2 SRaceDayQuads product specificationschecked 2026-07-27Quote 1, below the table
Maximum cell count decides fit6 SRaceDayQuads product specificationschecked 2026-07-27Quote 1, below the table
Battery connector decides fitXT30RaceDayQuads product specificationschecked 2026-07-27Quote 3, below the table
Continuous current decides fitAmps per motor the ESC sustains continuously. Vendors also quote a higher burst figure; this is the continuous one, the number that limits which motors the board can feed.55 ARaceDayQuads product specificationschecked 2026-07-27Quote 1, below the table
ESC firmwareDecides the configurator and the features, like bidirectional DShot for RPM filtering. Bluejay runs on BLHeli_S hardware but is its own firmware, so both names appear on the same box.BluejayiFlight product specificationschecked 2026-07-27Quote 4, below the table
  1. RaceDayQuads product specificationschecked 2026-07-27FC Specifications MCU: BGA-STM32F745 Gyro: BMI270 Blackbox: 16MB Onboard Flash BEC output: 5V 2.5A Barometer: DPS310 FC Firmware:IFLIGHT_BLITZ_F7_AIO Mounting pattern: 25.5 x 25.5mm φ3mm Dimensions: 35mm x 35mm Weight: 10.5g Input voltage: 2-6S, support LIHV battery ESC Specifications ESC MCU: BB21 Input voltage: 2-6S Support LIHV battery Output current: 55A, peak value 65A (10 seconds)
  2. Betaflight firmware: src/main/rx/rx.hchecked 2026-07-27typedef enum { SERIALRX_NONE = 0, SERIALRX_SPEKTRUM2048 = 1, SERIALRX_SBUS = 2, SERIALRX_SUMD = 3, SERIALRX_SUMH = 4, SERIALRX_XBUS_MODE_B = 5, SERIALRX_XBUS_MODE_B_RJ01 = 6, SERIALRX_IBUS = 7, SERIALRX_JETIEXBUS = 8, SERIALRX_CRSF = 9, SERIALRX_SRXL = 10, SERIALRX_TARGET_CUSTOM = 11, SERIALRX_FPORT = 12, SERIALRX_SRXL2 = 13, SERIALRX_GHST = 14, SERIALRX_SPEKTRUM1024 = 15, SERIALRX_MAVLINK = 16 } SerialRXType;
  3. RaceDayQuads product specificationschecked 2026-07-27Includes iFlight Blitz Whoop F7 AIO V1.1 (w/ 55A 8Bit 4in1 ESC) 2 x Capacitor 470uF/35V 1 x XT30U Male 18AWG cable 70mm 1 x 1.0-7P cable 50mm-28mm 1 x 1.0-7P cable 50mm
  4. iFlight product specificationschecked 2026-07-27ESC firmware: Q-H-40 - Bluejay, 0.16, 24kHz

Where to buy

This listing does not say which warehouse ships it. Most orders leave China, so expect import VAT and a carrier handling fee unless an EU warehouse is chosen at checkout.

Some links on this page earn us a commission at no extra cost to you, and that never affects any verdict on it. How this is funded.

What this fits

Checked against every other product in the catalog by the same engine the planner runs, rule by rule. Where a specification is missing the answer is unknown, which is a different answer from compatible.

Frame

Does not work with (8)Works with (10)Not enough recorded specification (2)

FPV camera

Not enough recorded specification (23)

Battery

Does not work with (11)Works, with a compromise (10)Works with (7)

Goggles

Not enough recorded specification (23)

Radio

Not enough recorded specification (37)

The standards this part is judged by

What the properties above actually mean, which differences are absolute, and where the names used in shops mislead.